Wireless M Bus

M-Bus (Meter-Bus) is a European Standard  for the remote reading of gas, water or electricity meters. M-Bus is also usable for other types of consumption meters. The M-Bus interface is made for communication on two wires, making it very cost effective.
This protocol exists with several physical layers such as paired wires, optical fiber or radio link.
The radio variant of M-Bus is called Wireless M-Bus and is specified in EN 13757-4. It is dedicated to the European ISM frequency band at 868MHz. It means that modules embedding the Wireless M-bus stack must comply with the general SRD standard EN 300-220 .


The Wireless M Bus specification defines 3 different ways to exchange data with remote meters:

• Mode T

In mode T, the meter sends spontaneously data, either periodically or stochastically.
– In Mode T1, the meter doesn’t care if any receiver is present or not. The meter sends data and returns immediately in IDLE without waiting for an ACK. This is a unidirectional communication.
-In mode T2 the meter sends its data and stays awake during a short time immediately after transmission to listen to a possible ACK. If no ACK is received, the meter returns in IDLE. If an ACK is received, then a bidirectional communication link is opened between meter and concentrator.

• Mode R2

In mode R2, the meter doesn’t send spontaneously data. The meter wakes up periodically in RX mode and waits for a wakeup frame received from concentrator. If no frame is received, the meter returns in IDLE. If a valid wakeup frame is received, a bidirectional link is then opened between meter and concentrator.

• Mode S

– Mode S1 operates exactly as mode T1 (unidirectional spontaneous transmission) but uses a different radio link described below.
– Mode S2 has the same behaviour as mode R (periodic wake up and wait for a wakeup frame before transmitting) but also with a different physical link.



Wireless M-Bus – Suppliers